Assembly and Washing Instruction

Warning: Teepee assembly must be carried out by an adult. Please make sure the teepee is securely assembled per the enclosed instructions to ensure safety of those playing in it.

 

1. There are four upper poles with holes at the top, four bottom poles, four connectors and one cord in the package. Take one from each pole and screw into the connector until you have four long poles each with a hole at the top.
2. Spread the teepee on the ground. Slip the poles into open corner seams. Weave the cord in and out of pole holes and fabric loops by order of one pole hole, one fabric loop.
3. Stand the teepee up. Cross the four poles and lean against one another by order below:
4. Right pole of entrance should lean on top of left pole of entrance.
5. Right back pole should will be next, leaning on top the two front poles (directly above)
6. The left back pole should be last, set on top of the back right pole.
7. Split the poles until the top opening of teepee forms a small square. Finally, wrap the cord tightly and tie a knot. Hang the LED light through the top opening and tie to one of the poles.

Tips:

1. Ironing the fabric prior the assembly will elevate appearance of teepee.

PLEASE NOTE: Steam iron inside out for patterned fabric

2. If the poles is loose, please wrap the threads part of the pole with food wrap before screwing into the connector to stable it.

Washing Instruction:

Machine washable with cold water and gentle cycle. Do not put in dryer. Hang or lay flat. Iron before dry.